User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix

x
Components and options listed below are included.
If any components are missing or broken, contact your retailer or your
nearest service center.
Supplied components
Item Quantity Remarks
Plotter unit 1 unit
Toner cartridge 3 units
For checking at the time of
installation
Waste bottle 1 unit Pre-installed
Quick Reference Guide 1 or 2 copies 200V: English and Chinese
CD-ROM 1 set
Paper flange 2 units/drawer
Process cartridge 1 unit With 2 ozone filters
Roll paper 1 box
A0, A1, A3 x 1 unit each, for
checking at the time of installation
Scanner exit guide 3 pieces MF model only
Panel sheet 2 sheets 200V only: English and Chinese
Power cable 2 units 200V only: 2 types
Options
Item Quantity Remarks
LP-817 (bucket) 1 unit
LP-819 (carrier sheet set) 1 unit MF model only
LP-840
(color upgrade kit-S)
1 unit
MF-S model
(North/South America and Europe)
LP-841
(color upgrade kit-L)
1 unit
MF-L model
(North/South America and Europe)
LP-842
(color upgrade kit-S)
1 unit MF-S model (Asia and Oceania)
LP-843
(color upgrade kit-L)
1 unit MF-L model (Asia and Oceania)