User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix
5-3
▼Setting parameter items
Chapter 5 "SETUP" Menu
uneMmetiyhcrareihtsriFmetiyhcrareihdnoceS
PUTES
PUTES
LGPH_nTROP#
)A(otrefeR
)1etoN
PUTES
_nTROP#NACSD
PUTES
FFIT_nTROP#
PUTES
SLAC_nTROP#
PUTES
ARAP#_LGPH
)A(otrefeR
PUTES
ARAP#NACSD_
PUTES
ARAP#FFIT_
PUTES
ARAP#SLAC_
PUTES
LGPH_BSU#
Note 1)
Disabled ports will not be indicated (refer to PORT select in the system menu.)
Only the PDL selected via PDL SELECT is displayed. (refer to PDL SELECT in the
Protocol menu.)
Parallel and USB will be indicated only when the respective interfaces are installed.
Setup menu setting parameter table