User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix

viii
DSCAN format
Please remember:
The DSCAN format described in this document as well as DSCAN that
appears on the operation display are for only customers in Japan.
Notation method
Markings
Note
Warning
Caution
◆ This mark indicates warnings that must be followed
carefully to avoid serious bodily injury or death.
◆ This mark indicates cautions that must be observed to
avoid damage to the equipment and bodily injury.
◆ Contain important information.
This is a “Tip” mark.
Contain additional hints for better use.
⇒ This is a “See” mark.
A reference section and page is indicated after this mark.