User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix

4-5
Chapter 4 Basic Menu Operation
■Choose input method
1 Press the [Enter] key to get ready for input.
2 Change the parameters using the [ ] (or [ ]) key.
▼Offline menu operation
Setting or changing the parameters
Press the [Enter] key to change the parameters.
Press the [ ] or [ ] key to select a parameter.
Shift the digits of a numerical value or character to enter a desired one
using the [ ] and [ ] keys.
Press the [Enter] key to select the parameter.
In some menus, the [Enter] key is used to execute the respective
functions.
Use the [Cancel] key to cancel the parameter entered.
(Cancellation of setting)
Me nu Mo d e
#AUTO SUPPLY
✽CONT MODE
[Enter] to Set
Me nu Mo d e
#AUTO SUPPLY
✽OPT IMAL MODE
[Enter] to Set
Me nu Mo d e
#AUTO SUPPLY
>CONT MODE
[Enter ] t o I nput