User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix

4-3
Chapter 4 Basic Menu Operation
Offline menu operation
Press the [MENU] key to enter the offline mode.
If data remains, some menus may not be displayed though key operation
is available.
Select the menu group using the [ ] and [ ] keys.
To enter each menu, press the [ ] key.
If any disabled key is pressed, a buzzer sounds.
Switching the menu on the same hierarchy
Press the [ ] or [ ] key to switch the menu within the same hierarchy.
An example of the setup menu group is shown below:
Me n u Mo d e
SETUP
#PORT1_HPGL
Me n u Mo d e
SETUP
#PORT1_DSCAN
Me n u Mo d e
SETUP
#PORT1_T I FF
Me n u Mo d e
SETUP
#PORT1_CALS
[ ], [ ] key
[ ], [ ] key
[ ], [ ] key
[ ], [ ] key