User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix
3-15
Chapter 3 Menu overview
Protocol menu “PROTOCOL”
Press the [ ] key on the display below to enter the Protocol menu.
After changing these settings, the system will reset.
▼Menu screen
Menu Item Function
PORTn : xxx The Ethernet port PDL selection and protocol name are
set here. N indicates the port number, xxx indicates the
Ethernet protocol type. Up to 10 ports may be specified.
PROTOCOL To set the protocol name, XPT sets the XPT port, LPD
sets the printer name, and FTP sets the user name.
PARALLEL Performs the PDL selection for the parallel channel.
Press the [ ] key
Me nu Mo d e
MENU
#PROTOCOL
Me nu Mo d e
PROTOCOL
#PORT1 : XPT