User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix
3-9
Chapter 3 Menu overview
Items which you can set
Set the device offline before performing setting operations. When you
press [MENU] Key to set the device offline, the following message
appears on the display.
Changed parameters are saved in non-volatile memory and are not lost
when the power is turned off.
Although the offline display appears even while printing, there are
functions which cannot be operated and these menus will not be
displayed.
Idle status
Me n u Mo d e
MENU
#SETUP
Me n u Mo d e
MENU
#DEV I CE
Me n u Mo d e
MENU
#PAPER
Me n u Mo d e
MENU
#FUNCT ION
Me n u Mo d e
MENU
#PROTOCOL
Me n u Mo d e
MENU
#RESET
Me n u Mo d e
MENU
#SYSTEM
[ ] key[ ] key