Specifications

6-49

FS '!' n Set Kanji Print Mode

Code 1CH 21H n

Function Sets a print mode for 2-byte characters.

Each bit of n is used as follows:

Bit Function n=0 n=1

Printing direction selection Horizontal writing Vertical writing

1 Undefined - -

2 Double-width Canceled Set

3 Double height Canceled Set

4 Kanji quarter size character Canceled Set

5 Kanji quarter size character position Subscript Superscript

6 Undefined - -

7 Under line Canceled Set

The underline is attached to all character widths, including right- and left-side character spacing.

However, it is not attached to the characters skipped by HT or other commands, or the

characters rotated by 90°.

The underline width is specified by FS '-' regardless of the character size. When the underline

width is not specified by FS '-', default width is set as 1-dot underline.

This command does not affect 1-byte character, however the only double-width mode is valid for

1-byte characters.

If the print mode can also be selected or canceled by another command, the most recently

processed command is effective.

The Kanji quarter size character can be selected or canceled in Kanji mode only. Bit 4 is ignored

in non-Kanji mode.

Default n=0