Specifications

6-43
6.5.11 Kanji Character Set Selection Commands
FS '&' Select Kanji Mode
Code 1CH 26H
Function Selects Kanji mode.
In Kanji mode, only 2-byte character codes are accepted.
1-byte character in SII Japanese font set (at shipping) can be printed by entering 00H
+ 1-byte
code.
This command is ignored when Shift-JIS is selected as the Kanji code system.
Default Cancel Kanji mode.
FS '.' Cancel Kanji Mode
Code 1CH 2EH
Function Cancels Kanji mode.
This command is ignored when Shift-JIS is selected as the Kanji code system.
Default Cancel Kanji mode.
FS 'C' n Select Kanji Code System
Code 1CH 43H n
Function Selects Kanji code system.
Only the least significant bit of n is valid.
n = 0: JIS code system.
n = 1: Shift-JIS code system.
The Kanji mode is canceled and the Shift-JIS is set to the Kanji code system when Shift-JIS is
selected as the Kanji code system by this command.
Refer to 6.3 CHARACTER CODES for character code system or applicable Kanji code
correspond.
Default Depends on the setting of SWDIP2-7.