Specifications

6-19
6.5.2 Formatting Commands
ESC 'C' n Set page Length at n Lines
Code 1BH 43H n
1
n127
Function Set page length at n lines.
The page length is (current line spacing x n) dot lines.
If the line spacing is zero, this command is ignored.
The current position becomes the beginning of the page.
The bottom margin set by ESC 'N' is canceled.
If n = 0, the page length is set at n inches.
This setting is canceled by Page Mode Select (DC2 'z' 0) command.
Moreover, this command is ignored in the page mode.
Default Cut paper mode : 38 lines (line spacing 34 dots lines)
Roll paper mode : No page length setting
Mark roll paper mode : 38 lines (line spacing 34 dots lines)
ESC 'C' 0 n Set Page Length at n Inches
Code 1BH 43H 00H n
1
n22
Function Sets the page length at n inches.
The current position becomes the beginning of the page.
The page length is n x 203 dot lines.
The bottom margin set by ESC 'N' is canceled.
If n = 0 or n
23, this command is ignored.
This setting is canceled by Page Mode Select (DC2 'z' 0) command.
Moreover, this command is ignored in the page mode.
Default Cut paper mode : 6.4 inches (1292 dots lines)
Roll paper mode : No page length setting
Mark roll paper mode : 6.4 inches (1292 dots lines)
ESC 'N' n Set Bottom Margin
Code 1BH 4EH n
1
n127
Function Sets the bottom margin at n lines.
The last dot (n x current line spacing) of the page is the skip amount (non-printable area).
The skip amount does not change even if the line spacing is set after setting the bottom margin.
The bottom margin is canceled when the page length is modified.
If the bottom margin exceeds the page length, this command is ignored.
If the page length is not specified in the initial state in the roll paper mode, this command is
ignored.
This setting is canceled by Page Mode Select (DC2 'z' 0) command.
Moreover, this command is ignored in the page mode.
Default The bottom margin is not defined.