Specifications

4-6
4.1.3 Function Settings(SWDIP3)
Table 4-3 Function Settings (SWDIP3)
Value
SWDIP Function
0 1
3-8 Reserved Fix to 1
3-7
3-6
Print Density See table below
3-5
3-4
3-3
Paper Select See table below
3-2
3-1
Paper Mode See table below
 Print Density selection
Normally, select the print density as 100%.
Print Density SWDIP3-7 SWDIP3-6
95% 0 0
100% 0 1
105% 1 0
110% 1 1
(NOTE) If too much energy is applied to the thermal head, it would shorten its life span and
cause the paper feed problem. Set an accurate thermal paper selection and print
density.
If selecting the thermal paper that is different from the one specified in the thermal
paper selection or in case of not setting the print density in 100%, verify the
performance with your actual device before printing.
 Thermal Paper selection
Select the thermal paper by Paper Select.
Paper Select SWDIP3-5 SWDIP3-4 SWDIP3-3
PD160R-N 0 0 0
TC98KS-LH 0 0 1
P350 0 1 0
Reserved 0 1 1
KT55F20 1 0 0
TF8067 1 0 1
TL69KS-HW76B 1 1 0
TF50KS-E2D (TP-341L-1) 1 1 1