Specifications

6-108
Note Using much of this command may cause the FLASH memory damage. It is recommended that
this command be used 10 times/day.
DC2 'i' m {DATA} Set Default/Set Test Print Header
Code 12H 69H m {Data}
Function Set default and test print header. Moreover, can be set various settings for Bluetooth.
m Function Data
30H Initializing of the test print header None
31H Reading test print header None
32H Writing test print header 0data<96 bytes+NULL
33H Initializing Bluetooth device name None
34H Reading Bluetooth device name None
35H Writing Bluetooth device name 2data<32 bytes+NULL
36H Canceling Bluetooth PIN code None
38H Writing Bluetooth PIN code 4data<16 bytes+NULL
40H Initializing default value None
41H Reading default value None
42H Line spacing 1 byte (00HdataFFH)
43H Character spacing 1 byte (00Hdata7FH)
44H Kanji left-side spacing 1 byte (00Hdata7FH)
45H Kanji right-side spacing 1 byte (00Hdata7FH)
46H International character 1 byte (00Hdata0CH)
47H Left margin 1 byte (00HdataFFH)
48H Right margin 1 byte (00HdataFFH)
49H Automatic power-off time 1 byte (00HdataFFH)
4AH Paper length to mark 2 bytes (00Hdata03E8H)
4BH Paper length of autoloading 1 byte (00HdataFFH)
60H Reading each default values 1 byte (42Hdata4BH)
Up to 96 bytes character strings can be set for the test print header.
Writing test print header is completed when data exceeds 96 bytes or the NULL character is
detected. When data exceeds 96 bytes, the printer uses 97th as NULL check code and
processes the following data as the command or 1 byte data.
Only LF(0AH) and CR(0DH) control codes can be used.
Control codes under 1FH except LF and CR are ignored and are not counted as data.
All 20H to FFH codes are processed as 1 byte code. 24-dot fonts are used for printing.
(Example)
Data: 'Portable Pinter' + 0DH
Print:
Portable Pinter
***********************
*DIP SWITCH 1*
.
.