Specifications

2-7
(1) Example of use of thermal label paper
An example of use of the thermal label paper is shown Figure 2-4.
(a) Set the function setting of
Paper Mode to “Mark Roll Paper”.
(b) Insert the thermal label paper.
(c) Set the page length as the length from the beginning of the current label to the beginning of the
next label.
(d) Set the skip amount (non-printing area) between labels.
(e) Print data within the printable area.
(f) Use Form Feed command to find the beginning of the next label. The mark on the next label is
detected and the beginning of the next label is located by sending Form Feed command.
The print start position after the beginning of the next label is placed at position 'a', and the paper
cut position is 'b' as shown in Figure 2-4.
Repeat ste
ps (e) to (f).
(NOTE) When Mark Position Correct of SWDIP 4-5 is set as Enable, the printer operates
paper feeding to backward 5 mm just before printing process after placing print
start position.
If this function set as Enable, use the thermal label paper 40mm or longer length to
prevent paper jamming from feeding paper backward.