Specifications

6-100
DC2 'E' n Motor Speed Select
Code 1DH 45H n
0
n255
Function Sets the motor speed high or low.
Value
Bit No. Function
0 1
0 Undefined - -
1 Undefined - -
2 Undefined - -
3 Undefined - -
4 Motor speed High speed Low speed
5 Undefined - -
6 Undefined - -
7 Undefined - -
Default n=0 (High speed)
DC2 'a' n Set Automatic Power-off Time
Code 12H 61H n
0
n255
Function Enables the automatic power-off function and sets the automatic power-off time.
n must be in the range 1 to 255 (minutes).
If n = 0, the automatic power-off function is off.
The initial status after power-up can be set by SWDIP 2-5.
Default n=30 (30 minutes)
Printer initial state after power-on can be changed by Set default/Set test print header (DC2 'i')
command.
DC2 '#' n Select Overlap Mode
Code 12H 23H n
Function Sets the overlap mode for ruler lines and characters to either OR or XOR.
Only the least significant bit of n is valid.
n = 0: OR overlap
n = 1: XOR overlap
When OR overlap mode is selected, dots part in the image or character is printed in black.
XOR means exclusive OR. When XOR overlap mode is selected, the part where the image and
character are overlapped is printed in white and the part where the image or character has a dot
is printed in black.
Default n=0 (OR overlap)