Specifications

2-5
(1) Example of use of the cut paper
An example of use of the cut paper is shown Figure 2-2.
(a) Set the function setting of
Paper Mode to “Cut paper”.
(b) Set the paper length as page length.
(c) Insert the cut paper.
(d) Print data within the printable area shown in Figure 2-3. (The position of print end must be at the
position of 15
mm or longer from the bottom edge of the paper.)
(e) The cut paper is ejected by sending Form Feed command at the end of printing.
Repeat steps (c) to (e).
Figure 2-3 Example for the Cut Paper
Paper length
(
90 to297mm
)
Page length  Paper
length
Paper ejection
15mm or longer
Printable area
6mm
A B C D E F
0 1 2 3 4 5
a b c d e f
Form Feed command