Specifications

8 - 1
CHAPTER 8
DESIGN OF PERIPHERAL DEVICES
8.1 MOUNTING THE PRINTER
The mounting procedure for MTP Series printers differs somewhat between the
MTP102 and the other printers in the serires.
Mount the printer so that it is not warped or distorted in any way.
8.1.1 MTP102 Printer
The MTP102 is provided on its back two
dowels and two holes diagonally for
mounting the printer (see Figure 8-1).
➀
When mounting with screws
Mount the printer by tightening the
tapping screws from under the
mounting base.
In this case, the dowels are used as
a reference for positioning (see
Figure 8-2).
Figure 8-1 MTP102 Printer (Back)
Figure 8-2 Mounting with Screws
(MTP102 Printer)