User Manual

64
HINT
•
The charging time depends on the ambient temperature and the voltage level of the
battery pack. Normally, using the battery charger "PWC-A071-A1", it takes about 4 hours
to complete charging after running down the battery pack. Using the quad battery
charger "PWC-A074-A1", it takes about 5 hours.
•
The battery charger and the AC adapter may get a little hot when in use. This is normal
and not a malfunction.
 Error Handling Procedure
Table 17-3 Error Handling Procedure
Phenomenon Possible Cause Corrective Action
LED doesn't light up The battery charger doesn't connect
to the power supply.
Securely connect the AC adapter
and the AC cable.
The AC adapter is failed or AC
cable is broken.
Replace the AC adapter or AC
cable with a new one.
The battery charger is failed. Replace the battery charger with a
new one.
LED shows other than green
lighting with no battery pack
installed
The battery charger is failed. Replace the battery charger with a
new one.
LED shows charging
temperature error
The battery pack temperature is out
of the operating temperature range
(charging).
The printer automatically resumes
charging when the battery pack
temperature is within the operating
temperature range (charging).
Wait for a while in the place where
the ambient temperature is 0°C to
40°C (32°F to 104°F).
LED shows battery
installation error
The battery pack is installed
incorrectly.
Install the battery pack correctly
again.
The terminal is in a contact failure. Remove the battery pack from the
battery charger, clean the terminal,
and install it again.
The battery pack is failed. Replace the battery pack with a new
one.
LED shows battery error The battery pack is failed. Replace the battery pack with a new
one.
LED shows hardware error The battery charger or AC adapter
is failed.
Replace the battery charger or AC
adapter with a new one.