User Manual

15. CHARGING BY CRADLE

Using the cradle, the battery pack can be charged.

The cradle is an optional accessory. See "20 SPECIFICATIONS" and "21 ACCESSORIES AND

CONSUMABLE PARTS", and be sure to purchase our specified accessories listed on these references.

NOTE

◆

The battery pack should be charged at 0°C to 40°C (32°F to 104°F).

 Each Part of Cradle

Figure 15-1 Each Part of Cradle (CDL-B02K-1)

1 Power connector

The DC plug of the AC adapter is connected.

2 Charging terminal

When setting the printer, this charging terminal is connected to the charging terminal of the printer.

 Charging by Cradle

The cradle is only for charging. Even when the cradle is connected to the printer, the printer cannot print

without the battery pack.

Depending on the state of the power supply at the start of charging, the battery pack can be charged in

2 modes.

• Power on charging mode: It is a mode to start charging from the state that the printer is on.

Communication and printing can be performed in charging.

• Power off charging mode: It is a mode to start charging from the state that the power is off.

Only charging is performed, and all the functions such as

communication and printing are stopped.

For the battery remaining capacity and the error status, see "7 LED INDICATION OF PRINTER".

Select the mode depending on the procedure.