User Manual

 Wireless LAN Interface

(1) When the USB cable is connected to the printer, disconnect it from the printer.

(2) Turn on the printer and connect it to the host device wirelessly.

In the factory shipment state, the settings are as follows:

Mode : Simple AP (simple access point)

Standard : 802.11b/g/n (2.4GHz frequency range)

SSID : SII-Printer

Security : None

IP address for the printer : 192.168.0.1

(3) View the page "http://192.168.0.1" from the Web browser.

The printer setting screen is displayed. Make necessary settings.

These settings are enabled after rebooting.

(4) Check the communication status on the host device.

(5) Send data from the host device, and verify that the data is printed correctly.

WARNING

◆

The printer may affect medical or other electronic devices. Obtain information and

data concerning influence due to radio interference from the respective manufacturers

or dealers.

◆

When using the printer in medical institutions, follow their guidelines.

◆

DO NOT use the printer in areas or zones where its use is prohibited.