User Manual

(3) A message of mode selection is printed as shown in Figure 10-3 when the test print has completed.

To return to the print-ready status, select "0 : Normal Mode".

To select other modes, press the FEED Switch the number of times corresponding to the selected

mode number, and then press the POWER Switch.

Figure 10-3 Mode Selection Message (Bluetooth Model)

[Mode Select]

0 : Normal Mode

1 : Setting Mode

2 : Wireless ON/OFF Mode

3 : Hex Dump Mode

Press the FEED switch an equal

number of times to the selected number.

After that, press the POWER SW.