User Manual

◆ Continuous printing with high print rate might cause temporarily stop printing by temperature

detection of the printer. Printing resumes when the printer's temperature cools down. When this

error occurs and "Data Discard Selection When Error Occurs" in the Function Settings is "Enable",

the print data transmitted during the error is discarded.

◆ In low temperature, the usable operating time of the printer may be shortened due to the

characteristics of the battery pack.

◆ The indicator of battery remaining capacity shown in the POWER LED is for reference. The battery

level may be significantly changed depending on the printer operation, so charge the battery pack

before the battery becomes low.

◆ The battery pack should be charged at 0°C to 40°C (32°F to 104°F).

◆ The charging time depends on the ambient temperature and the voltage level of the battery pack.

Normally, when using the printer or battery charger "PWC-A071-A1", it takes about 4 hours to

complete charging after running down the battery pack. When using the quad battery charger

"PWC-A074-A1", it takes about 5 hours.

◆ The battery pack, AC adapter and car charger may get a little hot when in use. This is normal and

not a malfunction.

◆ After using the battery charger, unplug the AC plug from the outlet. And make sure to remove the

battery pack from the battery charger.

◆ Always use the specified thermal paper. See "21 ACCESSORIES AND CONSUMABLE PARTS" for

details.

◆ DO NOT touch the thermal head directly. Doing so may result in poor printing quality due to the dirt

or damage by the static electricity.

◆ NEVER touch the thermal head, paper sensor, or platen roller directly while opening the paper

cover to install the thermal paper. Doing so may cause injury or other accidents.

◆ The printer has 2 paper cutters on the paper outlet: one is on the printer side, and the other is on

the paper cover side.

DO NOT touch the cutters directly with hands. Especially, make sure not to touch the exposed

cutters while the paper cover is open.

◆ Be careful not to get your fingers or hands caught in the printer when opening or closing the paper

cover.

◆ The AC adapter and car charger are only for charging. Even when the AC adapter or car charger is

connected to the printer, the printer cannot print without the battery pack.

◆ Charging the battery pack by the car charger is possible while the car engine is running or in the

accessory position. Ensure that the car battery remaining capacity is sufficient before using the car

charger in accessory position.

◆ After using the car charger, be sure to unplug the cigar plug from the car accessory socket.

◆ DO NOT print out during a vehicle driving. Ejected thermal paper may hinder driving of the vehicle.

◆ DO NOT drop or insert any foreign objects such as clips, pins, and screws in the internal parts or

slot of the products.

◆ DO NOT drop any liquid or spray a solvent to the products.

◆ NEVER use sharp object such as pen tip to push the switch on the operation panel.

◆ Make sure not to injure your body or other objects by the plate edge.

◆ When something goes wrong with the printer during use, stop using it immediately, and remove the

battery pack. And then, unplug the AC plug or cigar plug from the outlet or car accessory socket.

◆ NEVER disassemble the printer without a serviceman.