User's Manual
Table Of Contents
- COVER
- COPYRIGHT
- INTRODUCTION
- SAFETY PRECAUTIONS
- OPERATING PRECAUTIONS
- 1. PREPARATION
- 2. NAMES OF PARTS
- 3. POWER CONNECTING
- 4. PAPER SETUP
- 5. ATTACHING AND DETACHING THE BELT CLIP AND STRAP
- 6. TEST PRINTING
- 7. FUNCTION SETTINGS
- 8. CONNECTING TO THE HOST COMPUTER
- 9. CHARGING THE BATTERY PACK
- 10. THERMAL HEAD/PLATEN ROLLER MAINTENANCE
- 11. TROUBLESHOOTING
- 12. SPECIFICATIONS
- 13. OPTIONAL UNITS AND CONSUMABLES
- REAR COVER
-
47
-
11. TROUBLESHOOTING
Please check the following points before asking for repair.
■ Power does not turn on:
• Make sure the recommended AC adapter or battery pack is used.
• Make sure the AC cable and AC adapter are correctly connected.
• Make sure the AC adapter is correctly connected to the printer.
• Make sure the battery pack is fully charged.
■ Printer does not print:
• Make sure the interface cable is correctly connected.
• Make sure the interface cable that meets the Interface Specifications listed on page 49.
• Make sure the transmission conditions for the printer and the host computer are correct.
• Make sure the recommended paper is used and the paper orientation (top/bottom) is correct.
■ POWER lamp blinks:
• See the Lamp Indication on page 21.
■ Battery pack is not installed:
• Make sure the battery pack is correctly aligned.
• Make sure the correct battery pack is used.
■ Battery runs out soon after charging:
• Make sure the battery has been correctly charged.
• If the battery does not recover to its full charge, it is almost dead. Replace it with a new one.