User's Manual
Table Of Contents
- COVER
- COPYRIGHT
- INTRODUCTION
- SAFETY PRECAUTIONS
- OPERATING PRECAUTIONS
- 1. PREPARATION
- 2. NAMES OF PARTS
- 3. POWER CONNECTING
- 4. PAPER SETUP
- 5. ATTACHING AND DETACHING THE BELT CLIP AND STRAP
- 6. TEST PRINTING
- 7. FUNCTION SETTINGS
- 8. CONNECTING TO THE HOST COMPUTER
- 9. CHARGING THE BATTERY PACK
- 10. THERMAL HEAD/PLATEN ROLLER MAINTENANCE
- 11. TROUBLESHOOTING
- 12. SPECIFICATIONS
- 13. OPTIONAL UNITS AND CONSUMABLES
- REAR COVER
-
46
-
10.
THERMAL HEAD/PLATEN ROLLER MAINTENANCE
If paper dust accumulates, wipe and clean the thermal printhead and the platen roller to ensure the
print quality for long periods of time.
■ Cleaning the Thermal Printhead and the Platen Roller
(1) Power the printer off.
(2) Open the paper cover.
(3) Wipe gently the thermal printhead and the platen roller with a cotton swab that has been dampened
with a small amount of ethyl alcohol.
(4) Close the paper cover after verifying that ethyl alcohol remaining on the thermal printhead and the
platen roller disappears into thin air.
Platen roller
Thermal head
Standard model(-02∗/-16∗)
Hint
Do not touch the gears attached to the platen roller. Doing so might degrade the print
quality or cause a failure.