User's Manual
Table Of Contents
- COVER
- COPYRIGHT
- INTRODUCTION
- SAFETY PRECAUTIONS
- OPERATING PRECAUTIONS
- 1. PREPARATION
- 2. NAMES OF PARTS
- 3. POWER CONNECTING
- 4. PAPER SETUP
- 5. ATTACHING AND DETACHING THE BELT CLIP AND STRAP
- 6. TEST PRINTING
- 7. FUNCTION SETTINGS
- 8. CONNECTING TO THE HOST COMPUTER
- 9. CHARGING THE BATTERY PACK
- 10. THERMAL HEAD/PLATEN ROLLER MAINTENANCE
- 11. TROUBLESHOOTING
- 12. SPECIFICATIONS
- 13. OPTIONAL UNITS AND CONSUMABLES
- REAR COVER
-
45
-
CHARGE lamp (Recharge state indication)
Battery state CHARGE lamp
Not connected Off
During charging Red on
Charge completion Green on
Error Red blinks
Hints
•
If the CHARGE lamp does not light for a few minutes after start of charging, the
battery pack is out of order.
Stop using the battery pack.
•
If an error is detected in the battery pack, the CHARGE lamp blinks.
The error may be caused by going out of the battery life, so replace the battery pack
with a new’s.
•
The battery pack and the battery charger may be heated to a very slight extent during
charging. There is no problem.