User's Manual
Table Of Contents
- COVER
- COPYRIGHT
- INTRODUCTION
- SAFETY PRECAUTIONS
- OPERATING PRECAUTIONS
- 1 PREPARATION
- 2 EACH PART OF PRINTER
- 3 POWER CONNECTION
- 4 PAPER SETTING
- 5 TEST PRINTING
- 6 FUNCTION SETTING
- 7 CONNECTING TO THE HOST DEVICE
- 8 RECHARGING THE BATTERY PACK
- 9 THERMAL HEAD MAINTENANCE
- 10 TROUBLESHOOTING
- 11 SPECIFICATIONS
- 12 OPTIONS AND CONSUMABLE PARTS
- REAR COVER
-
31 -
Serial/USB Communication with an Interface Cable
(1) Turn the printer off.
(2) Open the interface connector cover and connect the interface cable. The connector
of serial interface cable has lock for preventing from falling off.
(3) Turn the printer on and send data from the host device to the printer.
(4) Verify that the data is printed correctly.
(5) The serial interface cable connector has a lock. To remove the cable, pull it out while
holding the lock. Pulling the connecter by force may cause connector damaged.
NOTE
- When connecting or disconnecting the interface cable, hold the
connector, not the cable.
- DO NOT connect the serial and USB interface cable at the same time.
If doing so, the USB communication mode has priority over the serial
communication.
USB interface cable
Serial interface cable
Lock