User's Manual
Table Of Contents
- COVER
- COPY RIGHT
- INTRODUCTION
- SAFETY PRECAUTIONS
- OPERATING PRECAUTIONS
- 1 PREPARATION
- 2 NAMES OF PARTS
- 3 POWER CONNECTING
- 4 PAPER SETUP
- 5 ATTACHING AND DETACHING THE BELT CLIP AND STRAP
- 6 TEST PRINTING
- 7 FUNCTION SETTINGS
- 8 CONNECTING TO THE HOST COMPUTER
- 9 CHARGING THE BATTERY PACK
- 10 THERMAL HEAD/PLATEN ROLLER MAINTENANCE
- 11 TROUBLESHOOTING
- 12 SPECIFICATIONS
- 13 OPTIONAL UNITS AND CONSUMABLES
- REAR COVER
- 33 -
Operation 3: Exit function setting mode
If you press the FEED button when the message shown below is printed,
you can return to “Operation 1:Transmission selection” (page 31) and set transmission
selection again.
DIP Switch setting mode.
Continue: FEED/Quit: REPRINT
If you press the REPRINT button, the message shown below is printed. The printer exits the
function setting mode and is turned off. The function setting is now completed.
Setting Mode Finished.
Hint
•
You can confirm the settings by test-printing after the function setting.