User's Manual
Table Of Contents
- COVER
- COPY RIGHT
- INTRODUCTION
- SAFETY PRECAUTIONS
- OPERATING PRECAUTIONS
- 1 PREPARATION
- 2 NAMES OF PARTS
- 3 POWER CONNECTING
- 4 PAPER SETUP
- 5 ATTACHING AND DETACHING THE BELT CLIP AND STRAP
- 6 TEST PRINTING
- 7 FUNCTION SETTINGS
- 8 CONNECTING TO THE HOST COMPUTER
- 9 CHARGING THE BATTERY PACK
- 10 THERMAL HEAD/PLATEN ROLLER MAINTENANCE
- 11 TROUBLESHOOTING
- 12 SPECIFICATIONS
- 13 OPTIONAL UNITS AND CONSUMABLES
- REAR COVER
- 31 -
Operation 1: Transmission selection
If you press the FEED button when the following message is printed, the printer moves to the
transmissions selection mode. When the REPRINT button is pressed, the printer moves to
the paper selection mode without changing the setting.
DIP Switch setting mode.
I/F=******** Change Setting?
Yes: FEED/No: REPRINT
(1) Input bit7 (MSB) through bit0 (LSB) in sequential order when the following message is
printed.
Input 8 bits.
1: FEED/0: REPRINT
When input [1] : Press the FEED button.
When input [0] : Press the REPRINT button.
For example, when setting “10101110,” continuously press the FEED, REPRINT, FEED,
REPRINT, FEED, FEED, FEED, and REPRINT buttons in order.
(2) When the FEED or REPRINT button is pressed eight times (for 8 bits), the printer outputs
the following message.
I/F=******** Save Setting?
Yes: FEED/No: REPRINT
When the FEED button is pressed, the printer outputs the following message and the setting
is saved.
I/F Setting=******** Saved.
When the REPRINT button is pressed instead of the FEED button, the printer outputs the
following message and the setting does not change.
I/F Setting Not Changed.
Hint
•
"********" shows a DIP switch setting. The left side digit shows the MSB (bit7) and the
right side digit shows the LSB (bit0).