User's Manual
Table Of Contents
- COVER
- COPY RIGHT
- INTRODUCTION
- SAFETY PRECAUTIONS
- OPERATING PRECAUTIONS
- 1 PREPARATION
- 2 NAMES OF PARTS
- 3 POWER CONNECTING
- 4 PAPER SETUP
- 5 ATTACHING AND DETACHING THE BELT CLIP AND STRAP
- 6 TEST PRINTING
- 7 FUNCTION SETTINGS
- 8 CONNECTING TO THE HOST COMPUTER
- 9 CHARGING THE BATTERY PACK
- 10 THERMAL HEAD/PLATEN ROLLER MAINTENANCE
- 11 TROUBLESHOOTING
- 12 SPECIFICATIONS
- 13 OPTIONAL UNITS AND CONSUMABLES
- REAR COVER
- 25 -
Hints
•
The printer function setting for the marked paper is different from that for non-marked
paper.
See Section 7, Function Settings, for details.
•
The printer also supports the paper roll of max. 58 mm external diameter.
If the internal diameter of the paper roll is different from that of the paper roll adapter, it
is necessary to reduce the external diameter of the paper roll against its loose-fitting.
For details, refer to the
MPU-L465 Technical Reference
.
•
When using a paper roll of a different width, remove the paper powder from the platen
roller before use.
See Section 10, Print Head/Platen Roller Maintenance, for cleaning the platen roller.
•
Using a paper roll for long periods of time may affect print quality.
(If a paper roll of a different width from the current installed one is installed for long
periods of time, the print quality may be degraded due to wearing of the platen roller.)
Hint
•
Do not touch the gears attached to the platen roller. Doing so might degrade the print
quality or cause a failure.