User`s guide

9
(3) Air flow
Air flow can be changed at three levels. The heater of this dryer is of constant
conduction type, and accordingly has characteristics that temperature drops as
air flow increases, or rises as air flow decreases.
To raise the drying efficiency, high air flow (H) is recommended during warm air
operation.
◆ Do not turn off the breaker until the fan stops three-minute operation
after the heater stops. When the breaker is turned off, the fan
stops turning, resulting in an increase in internal temperatures due
to remaining heat of the heater. This may cause failure of the dryer.
In addition heated surface may cause burns.
If the breaker is accidentally turned off, or the power cable pulled
out, turn on the breaker and the Power switch again, and operate
the fan with air flow set to H for more than five minutes to cool
down the dryer.
◆ If dust clogs the air inlet of the dryer, internal temperature goes up
and causes failure. Clean the dryer at regular intervals.
Note
◆ Do not sit on the dryer or put your hands with the weight. The dryer
does not have the strength of supporting human weight.
◆ Take care of the printed surface not to touch the operator or the
dryer. The printed media just coming out of the printer is not
completely dry. When someone or something touches the media,
the print result may deteriorate.
◆ Heat may damage the media if the dryer is too near to the media.
Keep at least 50 mm clearance between the dryer and media.
CAUTION