User`s guide

8
3.2 Operation Mode Characteristics
(1) Timer
- The initial value of the timer is 10 hours.
- The time on the timer does not change by pressing timer setup switches ▲
and ▼ while the fan is turning for three minutes after warm air operation is
finished.
(2) Start of warm air operation
-Warm air operation does not start by turning on the Heater switch 4 while the
Fan switch is pressed to blow air. To start warm air operation, turn off the Fan
switch 3 to stop air blow and turn on the Heater switch 4 .
-Warm air operation can be started by turning on the Heater switch 4 while the
fan is turning for three minutes after the Heater switch is off.
3.3 Efficient Use of the Dryer
(1) Direction of warm air
Set the body of the dryer
downward as shown in Figure 2-
5. Drying efficiency increases
with warm air blowing along the
surface of the media.
(2) When room temperature is low
Always turn on the heater to keep air from the dryer at room temperature + 10 to
20 ˚C. Raising the temperature to a certain level is required to dry the printed
media. Room temperature should be kept at 20 ˚C or more to increase drying
efficiency.
Media
Warm air
Dryer
Figure 2-5 Direction of warm air