User`s guide

2-34
How to switch the pressure
Switch over the pressure between the media feeding pressure roller and the grit
roller when using dierent medias.
The bottom position is normally used. When skew occurs in the media and the
media cannot be fed or when the media with weak elasticity such as a thin cloth,
switch to [weak] the center position. The pressure force is switched by the posi-
tion of the pressure roller up / down lever. (See gure below.)
<No pressure> (top)
When loading the media, raise
the lever. This the normal UP
position.
[Rear]
[Front]
<Normal Pressure> (bottom)
When loading the media, lower
the lever. It is the normal DOWN
position.
<Weak> (In the center)
The pressure force becomes
weak.
<No Pressure> (top)
When loading the media, raise
the lever. It is the normal UP
position.
<Normal Pressure> (bottom)
When loading the media, lower
the lever. It is the normal DOWN
position.
<Weak> (In the middle)
The pressure force becomes
weak.