User`s guide
2-26
2
Check the length of the take-up paper tube.
Use the paper tube of which length is identical to the width of the media set on
the printer, or shorter (by 9 mm at maximum.)
Note
- Do not use the paper tube which is longer than the media width. The media cannot
be taken up fully due to winding deviation.
(1) Set the ange spacer at the left side of
the roll media set on the paper feed side.
Press the paper tube end against the
ange spacer surface.
(2) While maintaining the state described above,
check the position (dierence in length) of the
right end of the roll media and the paper tube end.
Paper tube end
Flange
spacer
surface
Roll media
Paper tube end
Check the position
(dierence in
length)
Right end of
the roll media