User`s guide

2-22
Using a 2 inch core
In this equipment, by removing the 3 inch adapter, the 2 inch paper tube can be
used.
To remove the 3 inch adapter, the supplied attachment is needed. The removal
procedure of 3 inch adapter is explained below.
1
Insert the attachment in the hole in the
center of 3 inch adapter.
2
Turn counterclockwise ( in the arrow direction) the 3 inch adapter and
pull it out together with the attachment.
- Install the removed attachment into the left
and right plates to keep them for later use. (See
the gure at the right hand side.)
- Insert the 3 inch adapter in the slits (holes) of
the left and right plates and turn clockwise (
in the arrow direction).
- When installing the 3 inch adapter to the ange
again, push the hook (projection) of 3 inch
adapter in the slits (holes) of ange. Turn the
adapter clockwise (in the arrow direction).
The attachment is not necessary to install the 3
inch adapter, .
Attachment
3 inch adapter
<In case of installing the plate (right)>
3 inch adapter
Attachment
Slit (hole)
Hook
Attachment
3 inch adapter