User`s guide

2-16
How to use the take-up reel unit
Install the media on the take-up reel unit
1
Prepare the paper tube and waste paper (about 1 m) of which width is
identical to that of media to be used. And paste the waste to the paper tube.
Note
- If the media is not straight against the paper tube, it will cause skew.
- The width of paper tube for winding in the take-up reel unit should be the same as
that of roll media for printing. If the wider one is used, take-up shift may occur.
- Shift the blower unit to prevent any interference with the operation.
2
Move the Tension bar in the top position.
About 1m
Tension bar
Tension bar
Paper tube
Waste paper
<Tension bar xed position> <Tension bar top position>
Plate (right)
Plate (left)
Left side ange