User`s guide

2-8
4
After securing the ange by turning the
knob, pull out the ange spacer.
Note
- Tighten the knob of ange rmly. If the
ange is loosened, the media may not be
fed straight.
- During printing, the knob of ange
may loosen. Re-tighten the knob at an
appropriate time (every ten meters of
printing or before printing a long print
5
Install the ange at the left hand side of
the roll media.
(1) Install the ange spacer to the ange.
(2) Insert the ange in the roll media.
(3) Push the ange as far as it goes and x
the ange by turning the knob.
(4) Pull out the ange spacer.
Note
- When the end of the media is glued to the core, the glue may stick to the paper
guide and platen. If this happens, remove the glue and clean the platen.
6
Place right and left anges on the roll so they
set on the ange holders.
Roll
media
Flange
<In case of the roll media
with print side top exiting>
Print side
Print side
<In case of the roll media with
print side bottom exit->
In the direction of media setting
Flange holder
Knob
(1)
(2)
(4)
(3)
Flange spacer