User`s guide

5-16
Symptom/Possible Cause Resolution
The media advance is not properly
adjusted.
- [Suggestions for media advance
value]
(
P.5-22)
(1) Print in the image improvement [MEDIUM] or
[HIGH]. ( P.3-34)
(2) Print the media advance adjustment pattern and
adjust the media advance value. ( P.4-28)
(3) Change the pressure force using the Pressure
roller up/down lever. ( P.2-34)
(4) Print the media advance adjustment pattern again
and adjust the media advance value.( P.4-28)
(5) Print in the uni-direction print mode. ( P.3-26)
(6) Print in the print mode [QUALITY]. ( P.3-25)
Clogged Nozzles (1) Check that there is no dust on the platen, if any,
remove it. ( P.4-15)
(2) Perform the regular maintenance.( P.4-3)
(3) Implement (NORMAL ALL). ( P.4-19)
After this, run the nozzle print and conrm that
the lost print is improved. ( P.4-8)
(4) Clean the surface of Print head ( P.5-23)
After this, run the nozzle print and conrm that
the lost print is improved.( P.4-8)
- By adding the color stripe when printing,
the incidence of clogged nozzles will be
reduced. ( P.3-31)
Matching with the media is not
good. / The ink dries fast.
(1) Print the media advance adjustment pattern and
adjust the media advance value. (
P.4-28)
- [Suggestions for media advance value]
( P.5-22 )
(2) Raise the heater temperature. ( P.2-41)
(3) Print in the print mode [QUALITY] ( P.3-25)
(4) Print in the uni-direction printing. ( P.3-26)
(5) Print in the print mode [DENSITY] ( P.3-25)
(6) Print using the known good media that has been
used in the past