User`s guide

4-47
Maintenance and Adjustment / Replacement
4
Adjustment of take-up reel unit
As the state of roll media during operation always changes depending on the
state of roll media nishing (uneven wound) and the environment during printing
(such as temperature and humidity), wind the roll media while adjusting.
¢ How to print the adjustment pattern (In case of printing [TUR ADJ PRINT])
1
Set the printer to the oine. (Press
key.)
2
Press key twice to display ADJUST.
3
Press key and then key to select the
parameter (adjustment parameter name)
4
Select [TUR ADJ PRINT] with , keys
and press key.
5
Press key. Then, after warmed up, the
adjustment pattern [TUR ADJ PRINT] is printed.
Step 1
Step 2
hINK MEDIA REGi
fMEDIA M.ADVg
Initial adjustment
Note
- When executing the initial adjustment, set the take-up switch to OFF.
(
P.2-21 [Take-up switch setting])
1
Print the adjustment pattern [TUR ADJ PRINT].
- Shift the blower unit to prevent any interference with the operation.
- Instead of normal paper that is subject to being inuence by temperature and humidity,
a lm is recommended.
Before printing / take-up········· g Initial adjustment
<LCD display>
hPRINTER SETUPi
fADJUST HEATERg
#TEST PRINTS
*
NOZZLE PRINT
#TEST PRINTS
*
TUR ADJ PRINT
#TEST PRINTS
*
OK ?
#TEST PRINTS
*
EXECUTING
Problem during take-up ········· g Adjustment during operation