User`s guide
4-43
Maintenance and Adjustment / Replacement
4
[LS ADJ PRINT] adjustment procedure
Adjust the print position of the media. According to the print results of “LS ADJ
PRINT”, enter the adjustment correction value. This adjustment is required when
the K head is replaced.
STEP 1
Cut the edge of the media set to the printer with the media cutter blade.
NOTE
- Cut the edge of the media straight so that it is parallel to the platen. Without
doing so, proper adjustment cannot be conducted.
STEP 2
How to print the adjustment pattern [LS ADJ PRINT]
1
Set the printer to the oine. (Press
key.)
2
Press key twice to display ADJUST
MENU.
3
Press key and then key to display
[TEST PRINTS].
4
Press key, select [LS ADJ PRINT].
5
Press key. Then the adjustment
pattern shown in the gure below is
printed.
#TEST PRINTS
*
OK?
#TEST PRINTS
*
LS ADJ PRINT
#TEST PRINTS
*
NOZZLE PRINT
hPRINTER SETUPi
fADJUST HEATERg
hINK MEDIA REGi
fMEDIA M.ADVg
q Head position adjustment