User`s guide
4-26
7
Erect the Wiper sponge little by little while
drawing the Wiper sponge toward you.
After conrming that the liquid in the Wiper
sponge ows in the printer completely, pull
out the Wiper sponge.
8
Install a new Wiper sponge.
Insert it as far as it goes until it clicks.
9
Install a new Wiper cleaning liquid bottle.
(
P.4-23 [Wiper cleaning liquid
replacement])
10
Close the Cap cover and the front over.
11
Select [*YES] and press key to nish
the replacement.
Note
- The printer automatically tracks the time when the Wiper sponge is used and
displays the message prompting replacement of the Wiper sponge. On the
premise that a new Wiper sponge is installed and [*YES] is set, the value of
accumulator is reset.).
#REPLACE FINISHED
*
NO
#REPLACE FINISHED
*
YES