User`s guide

3-50
ADJUST MENU
Use this function when setting the mechanical adjustment parameters. To set the
mechanical adjustment parameters, press “
” key.
(1) Adjustment pattern
To perform the mechanical and electrical ad-
justments, print the adjustment pattern.
To stop printing, press key.
<Parameter (selection input)>
NOZZLE PRINT Prints the nozzle check pattern (without cleaning).
Use it for daily inspection.
PH TO PH Prints the head position adjustment pattern.
ADJUST PH R/L Prints the head right and left adjustment pattern.
BIDIRECTION1 When printing in the print mode other than [NORMAL2] and
[FINE DRAFT], set the value of bi-directional correction.
BIDIRECTION2 When printing in [NORMAL2], set the value of bi-directional
correction.
BIDIRECTION3 When printing in [FINE DRAFT], set the value of bi-directional
correction.
NOZZLE POS ADJ Prints the nozzle position adjustment pattern.
LS ADJ PRINT Prints the sensor position adjustment pattern.
TUR ADJ PRINT Prints the adjustment pattern for take-up reel unit.
key
#TEST PRINTS
>NOZZLE PRINT
hPRINTER SETUPi
fADJUST HEATERg
#TEST PRINTS
>NOZZLE PRINT