User`s guide

3-48
(7) PH HEIGHT ADJ
Used to adjust the Print head height. ( P.2-
44 [Change the Print head height])
(8) RESEAT PRINT HEAD
Check the poor contact of connector connec-
tion, based on the message.
(9) PH WARM
Head warming-up is used to warm up the
Print head. When the temperature inside the
printer is low, head warming-up is automati-
cally started immediately before printing. Use
the head warming-up to warm up the Print
head in advance before printing.
(1) When head warming-up is executed, the
message is displayed as shown on the
right side.
(2) When the Print head temperature reaches
to a certain level, the message is dis-
played as shown on the right side. Head
warming-up nishes after the carriage
moves to operate several scanning (and
also feeding the media by few cm).
#RESEAT PRINTHEAD
>
#PH HEIGHT ADJ
>
#PH WARM
>
#PH WARM
*PH WARMING UP XXm
#PH WARM
*EXECUTING
XX : Time required to nish the head
warming-up