User`s guide

3-26

4. DENSITY [high density print] (8 passes)

This mode is eective when printing transparent media (such as FF, transparent vinyl chloride). The print of

100 % is printed in 200 % at maximum. The printing speed is the same as that of [QUALITY].

5. DRAFT [productivity weight] (2 passes)

Printing is in the resolution of 720 × 360dpi. The printing speed is two times the [NORMAL1]. The print den-

sity is light comparing with [NORMAL1]. Depending on the print image, banding of print may be visible. The

entire print of 100 % is printed in 50 % of [NORMAL1]. It can be used for checking a layout.

6. FINE DRAFT [productivity + picture quality weight] (4 passes)

Printing is in the resolution of 720 × 540 dpi. The printing speed is the same as that of [NORMAL1]. The im-

age quality of photo is almost identical comparing with [NORMAL1]. As the entire print of 100 % becomes 75

% of that in [NORMAL1], if color density is a problem, use [NORMAL1] mode.

Note

- The recommended print mode is [NORMAL1]. Use other modes for increased

productivity or picture quality depending on customer requirements.

(6) PRINT DIRECTION

Select the print direction of a media.

BIDIR Printing occurs in two directions.

UNIDIR Printing occurs in only one direction.

#PRINT DIRECTION

>XX:BIDIR

XX : Selected media number

Bi-direction print

: Movement of Print head

: Print image

Uni-direction print

: Movement of Print head

: Print image