User`s guide

2-46
Adjusting the print head’s bidirectional position [BIDIRECTION

]
This function adjusts each print head’s bidirectional position, based on the print of
[BIDIRECTION]. Note the  indicates the number 1 to 4.
Note
Before bidirectional adjustment, forcedly set the media heater to ON to warm
up the printer for 30 minutes or more. Start the bidirectional ink spotting
adjustment only after conrming that the printer is warmed up suciently. The
adjustment may not be performed correctly when the printer is not warmed up
suciently.
For the procedure to warm up the media heater forcedly, see P.2-102.
–
STEP1 Printing the test pattern for [BIDIRECTION]
1
Set the printer to the oine state.
(Press the
ONLINE
key.)

INK MEDIA REG


MEDIA M.ADV

2
Press the
MENU
key twice to
display the menu group that
includes ADJUST.

PRINTER SETUP


ADJUST HEATER

3
Press the key and the key
to display TEST PRINTS.
#TEST PRINTS
>NOZZLE PRINT
4
Press the key to select
BIDIRECTION
, and press the
key.
#TEST PRINTS
>BIDIRECTION

Select 1, 2, 3, or 4 depending on
the print mode.
5
Confirm that the TEST PRINTS are
ready.
#TEST PRINTS
* OK?
6
By pressing the key, print the
test pattern below.
#TEST PRINTS
>EXECUTING