User`s guide

2-38
Setting media advance correction values
The factors that change the media advance correction values are as follows.
Change of print mode
Pressure change using the pressure control knob
Use/not use of take-up reel unit
Type of media
Difference in media feed route
–
•
•
•
•
•
1
Set media longer than 4 m.
Obtain the rough media advance correction value in [ROUGH] and determine
the media advance correction value in [DETAIL]. Both [ROUGH] print and [DETAIL]
print need paper of about 90 cm in length for one-time print. (To cancel printing
of media advance correction pattern, press the
CANCEL
key.
2
Set the printer to the oine mode.
(Press the
ONLINE
key.)

INK MEDIA REG


MEDIA M.ADV

3
Press the key and then
key to display the media advance
correction pattern.
#MEDIA ADV PRINT
>ROUGH(NORMAL1)
Select the print mode to be used normally for the media to set the media
advance correction value.
(For details of print mode, refer to P.4-2 [Print mode].)
Note
To obtain the media advance correction value in DENSITY2 mode, apply the
media advance correction patterns, ROUGH(QUALITY) or DETAIL(QUALITY).
–
4
Select the rough print mode with
the
and keys, and press
the
key.
#MEDIA ADV PRINT
*OK?