User`s guide

2-28
Cut-sheet media installation/removal procedure
1
Open the front cover, and move the media edge guards to each
side.
2
Rotate the pressure control knob clockwise to raise the pressure
roller (Open).
Takeup side Supply side
or
Pressure control knobs
3
Align the right end of the cut sheet with the guideline and insert
the cut sheet into the paper feeder.
4
Rotate the pressure control knob counterclockwise to lower the
pressure roller.
5
Set the media edge guards and
close the front cover.
CHECK EDGE GUARD
*OK?
Check that the media edge guards are not under the media or thick media is
not caught by inserting it forcibly. After conrming visually that the media edge
guards are properly set, press the key.