User`s guide

2-19
2
Basic operation

Media installation and removal
7
Install the drawn media to the paper tube.
Paper tube
Tape
Inner take-up:
Media is taken up with
its print surface comes
inside.
Outer take-up:
Media is taken up with
its print surface comes
outside.
(1) Check the take-up direction, remove
the slack of the media, and then
make sure that the media is not
deviated on the supply side and the
takeup side.
(2) With tape hold the media straight at
the center, and then at the rest six
positions in the direction from the
media center to the media edge.
Note
Be careful of the tape axing direction on the takeup side.
If the media is not installed straight to the paper tube, a skew of media may
occur.
–
–
8
Set the take-up direction switch according to the take-up
direction.
Take-up direction switch
OFF
 Outer take-up
- OFF
 Inner take-up