User`s guide

2-15
2
Basic operation

Media installation and removal
<General media in TENSION winding mode>
Usually put a tension bar suitable for the media width with a few exceptions.
<General media without take-up reel unit>
Put a tension bar which is half the width of the media.
<Vinyl chloride media>
Put an S size tension bar (without a ange) on the center of the slack.
Slacken off to a level lower than the
supply-side slack sensor.
When the slack reaches the sensor
detection area, the operation panel blips.
Supply-side slack sensor
Peel roller
Scroller
Note
Be sure to rotate the panel with the supply-side feed switch. Do not rotate the
peel roller manually, or the printer may be damaged.
–
19
Check the media setting.
Press the key.
SET MEDIA
*OK?
PREPARING MEDIA
PLEASE WAIT
Note
Rewind the printer's media completely at the end of the day. The PVC media
installed and left for a night on the printer may cause media jam.
–