User`s guide

2-14
17
This sign is displayed when the
slack is insu cient.
In case of use of sheet media, this
message is not displayed.
If the media slackness is insufficient, the
next operation will not be started.
-
-
CHECK
SLACKEN MEDIA
18
Press the tension bar to the peel roller’s upper part. Then create
a slack between the platen and the peel roller, by carrying the
tension bar to the rear side of the peel roller with a supply-side
feed switch (black).
Switch
Tension bar
Tension bar
Adjust the tension bar length and decide whether to attach a flange or not,
depending on the type and width of the media.
Examples of tension bar combinations
Size used Tension bar length
L 48 inches (123 cm)
L, S 64 inches (164 cm)
L, S, S 80 inches (204 cm)
L, M, S, S 104 inches (264 cm)