User`s guide

2-4
Power-on procedure
Connect the power cables in the following procedure.
1
Check that the Printer and
Heater power switches on the
rear panel of the printer are
off (O), and then connect the
supplied two power cables
between the power inlets of the
printer and power outlets.
Switch o (O) Power inlet
Power outlet
200 VAC, 15A
(in Japan)
2
Turn on (I) the Printer and
Heater power switches on the
rear panel.
Switch on (I)
Note
Do not use any power cable other than those supplied with the printer.
The supplied power cables are for 200 VAC only. Note that the shape of the plug
diers from that for 100 VAC.
Be sure to clamp the power cables with cable clamps. Otherwise, they may be
caught by the scroller resulting in electric shock or damage to the printer.
–
–
–