User`s guide

4-4

For convenience of explanation on the double-sided printing below, the side printed

rst is referred to as "rst side" and the side printed next is referred to as "2nd side." The

following procedure is described for the case to print the rst side of the media, reinstall

the media to the roll feed unit for each scroller that mound the media, and then print the

2nd side of the media.

First-side printing

2nd-side printing

Move

Scroller moves

Install the media.

For how to install media, refer

SELECT MEDIA

ROLL/SHEET:FACE

to P.2-7 "Media installation and removal." At this time, choose

"FACE" with the

or key for media selection.

Note

When using banner (with different undulations on the first and 2nd sides) for

single-sided printing, print the side with more undulations rst regarding it as

"rst side."

–

Install the media to the take-up reel unit.

For how to install media to the take-up reel unit, refer to P.2-16 to P.2-21

"Procedure to install general roll media to the take-up reel unit."

Since a margin of approximately 2.5 m or more is required for the 2nd-side

printing, wind about 4 turns of media to the take-up reel unit in advance.

Start printing on the rst side of the media.

Double-sided printing